Change risers/downpipes

Changes risers/downpipes across floors, including line symbols

Button:

Command name: ModifyVerticalPipes

  1. Select the lines to be changed in the drawing and confirm the selection with the right mouse button or the Enter key.
    Note:
    Cross-floor lines only need to be selected on one floor.
    The Change risers/downpipes dialogue opens.
Change rising/falling pipes
  1. Click on the Change button.
    1. From the Level from list, select the start day from which the lines start to build up.
      Tip:
      Refer to the floor height indicated behind the floor designation.
    2. From the Floor to list, select the end floor to which the lines are to be added.
      Tip:
      Refer to the floor height indicated behind the floor designation.
    3. From the Height from list, select the starting height in cm at which the line should begin.
      Note:
      The starting height refers to the upper edge of the finished floor.
      Note:
      The starting height position is used for all floors affected by the settings.
    4. From the Height position to list, select the final height position in cm up to which the line is to be generated.
      Note:
      The final height position is used for all floors affected by the settings.
    5. Exit the Draw risers/downpipes dialogue with the Ok button.
      The changes have been applied to all floors affected by the settings.
    6. Exit the command by right-clicking or pressing the Enter key.
Delete risers/downpipes
  1. Click on the Delete button.
    Note:
    The objects are removed across all floors.
    All lines, including line symbols, are removed from the floors.