Home
Drinking water
Drawing
Change (dendrite)
Create bends or chamfers
Creates bends or chamfers at the intersection of two lines in a selectable area

Drinking water
- Drawing
  - Start schema generator
    Starts the schema generator
  - Start floor generator
    Starts the storey generator
  - Room-based drawing
    The Room-based drawing window in the Drinking water and waste water section allows you to configure and display all rooms and room combinations within the drawing.
  - Insert drawing reference
    Inserts a drawing reference
  - Edit elevations
    Opens the elevation manager
  - Layer selection
    The buttons display the current trade layer.
  - Library
  - Favourites
  - Change (dendrite)
    - Draw line
      Creates straight line segments
    - Cable with component connection
      Draws a cable including component connection
    - Create route
      Opens the dialogue for configuring a route
    - Route with object connection
      Opens the dialogue for configuring a route with subsequent component connection
    - Connecting components
      Connects components to the pipe network
    - Trim pipe
      Trims protruding pipe ends
    - Smart deletion
      Deletes components and then closes the line gap or deletes the component's connection lines
    - Smart moving
      Moves objects, closes the line gaps and attaches the objects to a new location
    - Smart shifting of the height level
      Moves objects to a height position
    - Change layer
      Switches the currently used layer
    - Chamfer angle
      Creates a bevel at the intersection of two lines, the continuing line is cut off
    - Bevelling T-piece
      Creates a bevel at the intersection of two cables, the continuing cable is retained
    - Connecting pipes
      Connects two collinear pipes together
    - Smart cut
      Copies and moves one or more pipe network objects, existing pipe network objects are overwritten when pasted
    - Smart stretching
      Stretches or compresses a drawing while retaining the line connections
    - Create bends or chamfers
      Creates bends or chamfers at the intersection of two lines in a selectable area
    - Replace arches
      Replace bends
    - Draw risers/downpipes
      Adds risers/downpipes including line symbols across floors
    - Change risers/downpipes
      Changes risers/downpipes across floors, including line symbols
  - Cross-trade
  - Check
  - View
  - Centre & Zoom
    Use Centre and Zoom to determine the zoom behaviour during individual command calls
- Edit
- Calculate
- Simulate
- Analysis
- Labelling
- Document

Create bends or chamfers

Creates bends or chamfers at the intersection of two lines in a selectable area

Button:

Command name: CreateBends

Specify the lower left corner of the area boundary.
Specify the top right-hand corner of the area boundary.

The marked pipes are replaced by a bend element at the intersection of two pipes in the DHW and heating trades.

The marked pipes are bevelled at 45° at the intersection of two pipes in the waste water system.

Note:

For the CreateBends command to be executed successfully, the pipes must not be continued at the intersection.

Note:

When recording the pipe network, the structural design is taken into account when determining the deflection.