Home
Drinking water
Drawing
Change (dendrite)
Draw line
Creates straight line segments

Drinking water
- Drawing
  - Start schema generator
    Starts the schema generator
  - Start floor generator
    Starts the storey generator
  - Room-based drawing
    The Room-based drawing window in the Drinking water and waste water section allows you to configure and display all rooms and room combinations within the drawing.
  - Insert drawing reference
    Inserts a drawing reference
  - Edit elevations
    Opens the elevation manager
  - Layer selection
    The buttons display the current trade layer.
  - Library
  - Favourites
  - Change (dendrite)
    - Draw line
      Creates straight line segments
    - Cable with component connection
      Draws a cable including component connection
    - Create route
      Opens the dialogue for configuring a route
    - Route with object connection
      Opens the dialogue for configuring a route with subsequent component connection
    - Connecting components
      Connects components to the pipe network
    - Trim pipe
      Trims protruding pipe ends
    - Smart deletion
      Deletes components and then closes the line gap or deletes the component's connection lines
    - Smart moving
      Moves objects, closes the line gaps and attaches the objects to a new location
    - Smart shifting of the height level
      Moves objects to a height position
    - Change layer
      Switches the currently used layer
    - Chamfer angle
      Creates a bevel at the intersection of two lines, the continuing line is cut off
    - Bevelling T-piece
      Creates a bevel at the intersection of two cables, the continuing cable is retained
    - Connecting pipes
      Connects two collinear pipes together
    - Smart cut
      Copies and moves one or more pipe network objects, existing pipe network objects are overwritten when pasted
    - Smart stretching
      Stretches or compresses a drawing while retaining the line connections
    - Create bends or chamfers
      Creates bends or chamfers at the intersection of two lines in a selectable area
    - Replace arches
      Replace bends
    - Draw risers/downpipes
      Adds risers/downpipes including line symbols across floors
    - Change risers/downpipes
      Changes risers/downpipes across floors, including line symbols
  - Cross-trade
  - Check
  - View
  - Centre & Zoom
    Use Centre and Zoom to determine the zoom behaviour during individual command calls
- Edit
- Calculate
- Simulate
- Analysis
- Labelling
- Document

Draw line

Creates straight line segments

Button:

Command name: MagicLine

In the building services toolbar, select the height level in cm from the Height levels in cm list for the connections in a floor plan drawing.

Note:
The set height level refers to the top edge of the finished floor.

Tip:
You can change the height level while executing the command. To do this, select a different height level after executing the command without ending the command. The new catch point will be found automatically.
Activate the Automatic layer checkbox if the line layer is to be adopted from the starting point.
Select the starting point or the starting object for the pipeline.

Note:
You can start the pipeline directly at an existing line or select a component to which the line is to be connected. The automatic component connection finds the appropriate connection point.
Draw the pipework.
End the command with the Enter key or by clicking the right mouse button.

You can find more information on our YouTube channel.

Click here for the video - Basic Drawing in Building Services Change (Dendrit)

Click here for the video - Wastewater 2.0 seminar