Draw risers/downpipes
Adds risers/downpipes including line symbols across floors
Button: 
Command name: AddVerticalPipe
Area Level from
-
From the Level from list, select the start day from which the lines start to build up.
Tip:Refer to the floor height indicated behind the floor designation.
Range level to
-
From the Floor to list, select the end floor to which the lines are to be added.
Tip:Refer to the floor height indicated behind the floor designation.
Elevation from
-
From the Height from list, select the starting height in cm at which the line should begin.
Note:The starting height refers to the upper edge of the finished floor.Note:The starting height position is used for all floors affected by the settings.
Elevation to
-
From the Height position to list, select the final height position in cm up to which the line is to be generated.
Note:The final height position is used for all floors affected by the settings.
- Deactivate the Automatic layer checkbox to prevent automatic switching of the medium from the currently active layer when continuing existing lines.
- Exit the Draw risers/downpipes dialogue with the Ok button.
-
Use the crosshairs to place the string symbol on any floor. You can perform single and multiple placement.
The lines including line symbols are added to all floors affected by the settings at the same positions within the floor frames.
- Exit the command by right-clicking or pressing the Enter key.