Home
Appendix
Extended command reference
Component exchange
Exchanges components of the same type

Appendix
- Pipe network basics
- Dialogues and additional information
- Component Library Report
- Extended command reference
  - Copy
    Copies an object to the clipboard
  - Cut
    Cuts out an object and saves it to the clipboard
  - Paste
    Inserts an object from the clipboard into the drawing
  - Repeat
    Undoes the effects of previous UNDO commands
  - Undo
    Undoes the effect of commands
  - Place component
    Places components in the drawing
  - Parallel placement
    Places pipe components in parallel in lines
  - Component exchange
    Exchanges components of the same type
  - Route with component connection
    Draws a route including component connection
  - Processes existing building frames
    Edits existing building frames
  - Pick up wall
    Grips walls and wall openings
  - Pick up windows
    Grips windows
  - Tapping roof windows
    Taps roof window
  - Pick up door
    Picks up doors
  - Pick up/edit roof/dormer geometry
    Grips roofs or dormers
  - Pick up floor/ceiling
    Grips floors/ceilings

Component exchange

Exchanges components of the same type

Command name: ExchangeComponents

Button:

Select the component to be placed in the drawing.
Show the component to be replaced in the drawing.
The new component and the component to be replaced must both be of the same type. This means that both components must be tubular components or both must not be tubular components.
Specify a drawing area in which the components are to be replaced by entering two corner points.
All components that match the selection are replaced in the specified drawing area.
Note:
The rotation angle of the original component is retained during the exchange.

You can find more information on our YouTube channel.

You can access the video here