Appendix
- Pipe network basics
- Dialogues and additional information
- Component Library Report
- Extended command reference
  - Copy
    Copies an object to the clipboard
  - Cut
    Cuts out an object and saves it to the clipboard
  - Paste
    Inserts an object from the clipboard into the drawing
  - Repeat
    Undoes the effects of previous UNDO commands
  - Undo
    Undoes the effect of commands
  - Place component
    Places components in the drawing
  - Parallel placement
    Places pipe components in parallel in lines
  - Component exchange
    Exchanges components of the same type
  - Route with component connection
    Draws a route including component connection
  - Processes existing building frames
    Edits existing building frames
  - Pick up wall
    Grips walls and wall openings
  - Pick up windows
    Grips windows
  - Tapping roof windows
    Taps roof window
  - Pick up door
    Picks up doors
  - Pick up/edit roof/dormer geometry
    Grips roofs or dormers
  - Pick up floor/ceiling
    Grips floors/ceilings

Processes existing building frames

Edits existing building frames

Command name: EditLevelgenerator

Double-click on a building frame that has already been placed to open the change dialogue.

Floor definitions

Define the standard floor structure in the Floor generator dialogue on the left-hand side of the dialogue.
- In the Top floor input field, adjust the floor number of the top floor for newly created floors.
- In the Bottom floor input field, adjust the floor number for newly created bottom floors.
  Note:
  Entries with a negative sign are required for basements and the ground floor.
- In the Floor height input field, adjust the floor height in metres for newly created floors.
- In the Ceiling thickness input field, adjust the ceiling thickness in metres for newly created floors.
- In the Floor structure input field, adjust the height of the floor structure in metres for newly created floors.
- In the Storey width input field, adjust the width for the storey.

Storey table

Adjust the default values in the columns Designation, Storey height (m), Ceiling thickness (m) and Floor structure (m) for the respective storey.
From the Reference storey drop-down menu, select a reference storey from the storey table.
Adjust the height for the reference storey in the Height of top edge of floor above ground level input field.

Placement

Click OK to close the storey generator and transfer the building to the drawing.