Heating load/heating surfaces
- Heating load
  - Display heating load / heating and cooling surface design
    Displays the heating load / heating and cooling surface design
  - Insert drawing reference
    Inserts a drawing reference
  - Tapping components
    Tapping various components in the drawing
  - Components
  - Set room symbol
    Sets a room symbol
  - Record room geometry
    Captures all components and symbols belonging to the heating load for a room geometry
  - Assign U-values
    Assigns a defined U-value to horizontal components
  - Create floors
    Create floors
  - Create ceilings/roofs
    Create ceilings/roofs
  - Creating ceilings/roofs and floors
    Creates ceilings/roofs and floors
  - Copying heating load components
    Copy heating load components
  - Form intersection line roof - storey
    Forms the intersection line between roof or dormer and storey
  - Connecting roofs/dormers
    Connects roofs/dormers
  - Show roof height
    Displays the height of roofs and dormers
  - Display heating load/heating surface object
    Displays rooms, ventilation and air conditioning symbols and components as well as heating surfaces in the heating load/heating surface
  - Display overflows
    Displays overflows
  - Show 3D model
    Displays the 3D model
  - Reset heating load
    Resets the basic settings for all components and rooms for the next recording
  - Cross-trade
  - View
  - Centre & Zoom
    Use Centre and Zoom to determine the zoom behaviour during individual command calls
- Heating surfaces
- Document

Connecting roofs/dormers

Connects roofs/dormers

Button:

Command name: ConnectRoofs

Ensure that the distance between the components is not greater than 10 cm so that connected roofs/dormers are correctly recorded. You can use this command to correct tapped roof areas.

Note:

Hide unneeded layers before executing the command so that you can select the correct component. The starting point and the valley of the selected primary roof are stretched/compressed.

Start the command using the button or enter connectroofs in the command line.
Select the dormer/flange (valley) that you want to change.
Select the side of the dormer/flange (valley) that you want to stretch/compress.
Select the primary roof you want to connect to.