Home
Drinking water
Drawing
Cross-trade
Create reference point
Inserts reference points in floor frames

Drinking water
- Drawing
  - Start schema generator
    Starts the schema generator
  - Start floor generator
    Starts the storey generator
  - Room-based drawing
    The Room-based drawing window in the Drinking water and waste water section allows you to configure and display all rooms and room combinations within the drawing.
  - Insert drawing reference
    Inserts a drawing reference
  - Edit elevations
    Opens the elevation manager
  - Layer selection
    The buttons display the current trade layer.
  - Library
  - Favourites
  - Change (dendrite)
  - Cross-trade
    - Show trade-dependent layer structure
      Displays the trade-dependent layer structure
    - Insert smart block
      Opens the dialogue for inserting a smart block
    - Create smart block
      Opens the dialogue for creating a smart block
    - Insert image
      Opens the dialogue for inserting an image
    - Open project editor
      Opens the project editor
    - Edit building data
      Edit building data
    - Create floor frame
      Creates a level frame
    - Create reference point
      Inserts reference points in floor frames
    - Measure area and perimeter
      Measures the area and perimeter of objects or defined areas
    - Measure length
      Measures the distance between two points
    - Align user coordinate system
      Aligns the user coordinate system using two freely selectable points
    - Rotate user coordinate system to 0°
      Resets the rotation of the user coordinate system to 0°
    - Optimise pipe network
      Optimise the pipe network
    - Edit CAD settings
      Opens the CAD configurations
    - Insert multiline text
      Inserts multiline text
  - Check
  - View
  - Centre & Zoom
    Use Centre and Zoom to determine the zoom behaviour during individual command calls
- Edit
- Calculate
- Simulate
- Analysis
- Labelling
- Document

Create reference point

Inserts reference points in floor frames

Button:

Command name: CreateReferencePoint

Reference points are required to superimpose the individual floor plans in multi-storey buildings. It must be set at a point that is identical on all floors (e.g. lift shaft). If the reference points are not exactly on top of each other, the areas cannot be calculated correctly.

Place a reference point in each floor plan. The reference points must lie exactly on top of each other.

Click here for the video