Select material configuration

Displays and changes the selected material configuration

Button:

  1. In the ‘Select Material Configuration ’ dialogue box, select the desired configuration by clicking the button.
  2. Confirm your selection by clicking OK.
The selected material configuration is applied to all trades, where applicable. The selected material configuration is displayed in all views in the upper section of the building services toolbar.
Clicking on the manufacturer’s logo in the building services toolbar will take you back to the ‘Select Material Configuration’ dialogue box. The currently selected material configuration is highlighted in grey and can be changed using the buttons.

Trades: Drinking water, Wastewater, Heating:

Note:
To change the material configuration at a later stage, call up the ‘Select Material Configuration ’ command again or click on the manufacturer’s logo in the building services toolbar to reopen the selection dialogue. The currently selected material configuration is highlighted in grey.

Heating load trade:

Note:
If you have a ‘Tabular Heating Load – Heating Area – Cooling Area’ document in the project, you can change or view the material configuration by double-clicking in the Project Explorer.The currently selected material configuration is highlighted in grey. Clicking ‘OK ’ in the ‘Select Material Configuration ’ dialogue box opens the Dendrit heating load/heating and cooling load design.